Tips For Fixing
Xbox 360 Heat Issues

There is nothing more troubling than watching a movie or playing a game and having to deal with the system freezing up.  Whether you are dealing with heat issues or other problems causing the system to freeze up, it is a nuisance to deal with.  Luckily, there is information for fixing Xbox 360 in these circumstances.

As you are probably well aware of, heat needs to be removed from your Xbox in order for it to function properly.  As soon as you begin to see the system freeze up or odd artifacts in the graphics, chances are it is time to clean out your console. 

There is the chance that game lockups can be caused by DVD issues.  But if you are experiencing problems only while playing games and in specific spots during the games, you are probably due for a clean-up.  There is way of fixing Xbox heat issues so that you can enjoy your games and movies again without having to deal with game lockups. 

When opening the console you are going to remove the hard drive and the DVD drive while leaving the rest of the system intact.  You want to start by blasting out the heat-sinks with compressed air while working your way out.  If you have purchased a new can of air, use a little away from the system first to avoid spraying out the liquid propellant as you move through your Xbox.  You can cause serious damage to the board and electronics by spraying the subzero liquid.

It is important to note that the heat generators are circled in red and the cooling inlets and outlets are in blue.  From there, you want to continue spraying compressed air by cleaning the dust from the surface of the board.  Make sure you pay close attention to the air holes at the front and sides of the case as these holes can be serious problems fixing Xbox heat issues.

After cleaning the motherboard with compressed air your next step toward fixing Xbox 360 is to remove the backing from the heat-sink while placing it squarely on top of the chip.  Put firm pressure on the backing for at least two minutes.  The last step is to replace the standard power course for the fan with a higher voltage power source.  This should improve the fan speed eliminating the system from freezing up or having any game lockups.